Growing tired of seeing the same design of the Rubik’s Cube? Well, this DIY will help you spice up the fun and designs of the Rubik’s Cube.
- 1 Rubik’s Cube
- 6 Photos (I’ll be using 6 Smallies)
- A paper (I’m using an unused photo instead)
Let’s get started!
Measure one face of the Rubik’s cube. Once measured, draw out a square on the blank paper using the measurements. Cut along the lines.
Use this blank cut-out as a guide when cutting the photos.
I used it as a guide to roughly know where to cut out for the main subject of the photos. Below I use the cut-out guide to mark the place I want to cut. I used a marker to make it more noticeable.
Once you cut out the main subject of each photos. Measure the small squares of the cube.
Then draw lines on the cut out photo based on the measurement. Label each box to ensure that the order would not be mix up.
Once done, cut along the lines. Then, paste it on one side of the cube using either glue or tape. Cut any excess if it protrude out of the small squares. It should look like this once pasted. (A/N: I cut the edges to be more rounded so that the edges will not be sharp.)
Repeat again until you have covered all sides of the cube. And there you have it! Your very own Rubik’s photo cube. Great for gifts or decoration.
You can purchase the Smallies here. Have fun doing this DIY! ‘Till next time!